Customized bolt manufacturing - What should be paid attention to when processing precision hardware parts?
Customized bolt manufacturing - Before mechanical work, check whether the moving parts have been lubricated, then start and check whether the clutch and brake are normal, and run the machine idle for 1-3 minutes. It is strictly prohibited to operate the machine if there is a malfunction.
Customized bolt manufacturing - Maintain the correct posture while working, have sufficient mental energy to cope with the work, and immediately leave the work post and report to the leader if you feel unwell.
Customized bolt manufacturing - During operation, it is necessary to concentrate, avoid casual conversation, and cooperate with each other. Operators should not operate in a restless or tired state to avoid accidents and ensure safe operation.
Non standard custom manufacturers - all employees check whether their clothing meets job requirements before entering the workplace. Do not wear slippers, high heels, or clothing that may affect safety. Those with long hair must wear a safety helmet.
Non standard custom manufacturers - When replacing molds, the power should be turned off first, and the punching machine movement department should stop running before starting to install and debug the molds.
Non standard custom manufacturer - After installation and adjustment, move the flywheel by hand for two trial runs to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the edge pressing ring is in a reasonable position.
Non standard custom manufacturers must wait for all other personnel to leave the mechanical work area and remove debris from the workbench before starting the power supply to operate the machinery.
Non standard custom manufacturers - When working with machinery, it is strictly prohibited to insert hands into the slider working area and to use hands to take or place workpieces. When taking and placing workpieces in the die, tools that meet the standards must be used. Non standard customized manufacturers - If any abnormal noise or machine malfunction is found, the power switch should be immediately turned off for inspection.
Non standard customized manufacturers - After the machinery is started, one person is responsible for transporting materials and operating the machinery. Others are not allowed to press the power building or step on the foot switch board, nor can they put their hands into the mechanical work area or touch the moving parts of the machinery with their hands.
Screw manufacturer - When leaving work, the power should be turned off and finished products, scraps, and miscellaneous items on the job should be sorted out to ensure a clean and safe working environment.
