Threaded rods and bolts - what should be paid attention to when processing precision hardware parts?
Threaded rods and bolts - Before mechanical operation, check if the moving parts have been lubricated, then start and check if the clutch and brake are normal, and run the machine idle for 1-3 minutes. It is strictly prohibited to operate the machine if there is a malfunction.
Threaded rods and bolts - Maintain the correct posture while working, have sufficient mental energy to cope with the work, and if you feel unwell, immediately leave the work post and report to the leader.
Stamping and welding parts - During operation, concentration must be maintained, casual conversation is strictly prohibited, and mutual cooperation is necessary. Operators should not operate in a state of restlessness or fatigue to avoid accidents and ensure safe operation.
Stamping and welding parts - All employees check their clothing to ensure it meets job requirements before entering the workplace. Stamping and welding parts - Do not wear slippers, high heels, or clothing that affects safety. Those with long hair must wear a safety helmet.
Customized bolt manufacturing - When replacing the mold, the power should be turned off first, and the punching machine movement department should stop running before starting to install and debug the mold.
Customized bolt manufacturing - After installation and adjustment, move the flywheel twice by hand to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the edge pressing ring is in a reasonable position.
Hexagonal socket bolt - The machine can only be powered on after all other personnel have left the mechanical work area and removed any debris from the workbench.
Hexagonal socket bolt - During mechanical operation, it is strictly prohibited to insert hands into the sliding block working area and to use hands to take or place workpieces. When taking and placing workpieces in the die with spring nuts, standard tools must be used.
Spring nut - If any abnormal noise or malfunction is found in the machine, the power switch should be immediately turned off for inspection.
Spring nut - After the machine is started, one person is responsible for material transportation and mechanical operation. Others are not allowed to press the power building or step on the foot switch board, nor can they put their hands into the mechanical work area or touch the moving parts of the machine with their hands.
Spring nut - When leaving work, the power should be turned off and the finished products, scraps, and miscellaneous items on the job should be sorted out to ensure a clean and safe working environment.
